by Ed
(Crystal River, Citrus County, FL)
This engine is mounted on Seaark RXJT180, while running in skinny water, hit something hard with lower unit. Was going about 20mph. Stopped the engine, went to trim up engine, just click. Started engine, ran fine, pumped water , went home. Located trim solenoid, removed leads to trim motor, jumped with 12 volt, nothing. Ordered new trim motor, replaced, works fine. Is there any setting on motor to let engine flip up if it hits something? Other motors I have had with out power trim, let you flip a lever to release hold on motor.
Email: ecdietrich2@gmail.com