by Jo
(Kaw city ok)
98 bay liner Capri when I put it in forward and going across the water , I get a beeping noise! Sometimes I can let off the throttle and it will quit . But seems to b doing it a lot
Return to FISHING and BOATS FORUM
by Wayne
(Kitchener ON Canada)
I have a 1996 Lund Rebel Adventure series with a 30 hp Merc 2 stroke. As soon as I turn the key to the on position there's a warning buzzer that comes on before the motor is even running and the buzzer stays on. Any ideas what this buzzer might be for? Thanks.
Return to FISHING and BOATS FORUM
by Paul colella
(Port charlotte florida)
Maxxum 2900 alarms sounding when icreasing throttle temp at 185 ,oil level in engine good.
Return to FISHING and BOATS FORUM
by Jerry
(Townsend GA. USA)
I have a 1970 Proline 21' boat with an out board motor. The last few times I have taken the boat out, after about an hour of being on the water, a gauge that appears to be some sort of a radio wave signal begins to beep. It stays on until I shut the motor off. Once again after about another hour of operating, it will start beeping again. Is this an overheating situation? Any guidance would be appreciated.
Return to FISHING and BOATS FORUM
by Chris Contreras
(Redlands CA. USA)
I have a 1992 Sea Swril 190SE. It's powered by an Evinrude Intruder 150. My problem is when I turn the key the buzzer goes off underneath the dash by the steering wheel before I even start the boat. I'm not surewhat this buzzer represents. My two stroke oil is full. I have clean fuel. A little backstory I rescued this boat out of my in-laws backyard. I took it out for one season had fun and then it set for 3 years. Did some typical maintenance changed the fuel, topped off the two-stroke oil went to start it and the buzzer went off right when I turn the key to the on position. I'm not a rich man any help that you could send my way would be greatly appreciated.
PS. Try to attach a picture said it was too large. Tried to to minimize it still wouldn't take it sorry let me know if there's another way I can get you a picture.
Return to FISHING and BOATS FORUM
by George demetrio
Have yahama 10 micron fuel filter Almost ran out of fuel. Did fill up and finally did prime system and boat began to operate properly. Red light on tachometer and beeping continously. How do I stop the beeping? Forgot to mention this on eapro.almost w 200 suzuki.
Woodydemetrio@yahoo.com
Return to FISHING and BOATS FORUM
by Roger
(Parrish, AL)
My 2000 sundancer has a 90 evenrude on it and it has started beeping with the check engine light and oil light flashing. changed plugs, oil is full, runs great but still beeping. What do I do?
Return to FISHING and BOATS FORUM
by Bob Fitzgibbon
(Miami, Fl)
My boat has 2 Volvo Penta I/Os. When I leave wake speed and throttle up to full throttle alarm sounds in about 3 to 4 minutes and the engines back down by themselves. Any ideas?
Bob in Miamai, Fl
Return to FISHING and BOATS FORUM
by William irwib
(Ontario Canada )
I. Have. A 1988 Doral boat with a 100 Mariner on it. And. Today. The. Control started making. A beeping noise
Even when. The. Motor is not running
But. When I disconnect the. Battery while running. The. Beeping noise goes away what. Would. My. Problem be ??
Return to FISHING and BOATS FORUM
by Kimberly Stotts
(Davenport Wa)
Why am I hearing a beep sound every couple minutes when i turn the fresh water switch on? We have a 2006 Regal 33 ft cruiser
Return to FISHING and BOATS FORUM
by Aric
i have a 2003 135 2 stroke. it starts fine and idles fine, but when I go to put it on plane the continues beep comes on and the engine is limited on power, sometimes I was able to throttle back and try a couple times and it would eventually work, other times I would turn the boat off start it back up and it would go on plane no problem, but once I had to shut the boat off twice to get it to work.
Return to FISHING and BOATS FORUM
by Chad DeVore
(Picayune, MS)
I have a 2008 4.3 Mercruiser, I changed the oil and filter. When I start the motor an alarm goes off. I'm assuming this is the oil pressure switch but gauge shows 40 psi at idle. I checked the blue wire to oil sensor and it was connected. Am I overlooking something or could this be another alarm?
Return to FISHING and BOATS FORUM
by Randy Robertson
(Decatur,IL. Macon county)
Everytime I turn on the key to start my 115 h.p. mercury I get a alarm coimg from the forward and reverse control box. The oil injection and water pump is working fine. This alarm stays on even after motor starts. This started late last summer. What is causing this alarm?
Comments for Alarm going off
|
||
|
||
|
||
|
||
by Tia Wing
(Watts , OK)
I have a pontoon with a 70 horse power evinrude the oil injection system has been removed. But when at higher throttle ranges the shifter beeps like beep beep beep and from what I read this comes from the oil mixture and injecters. We mix it at 50 to one. Is there anything else that would cause this and is it safe to disconnect it.
Return to FISHING and BOATS FORUM
by Mark
(Chesapeake, VA)
I have a 1999 mercruiser 5.7l 350 c.i.d engine in my Sea Ray 210 Sundeck. New outdrive installed this spring.
After about 5 minutes running at 3000 rpm, the alarm comes on intermittently. 1/2 second alarm that repeats every 2 seconds. Temp running at 170 per gauge, manifolds not so hot you cannot hold hand on them. Oil pressure steady at 60 psi and oil level full. Stern Drive gear lube full. Disconnected the temperature sender while on the water (easy to get to) but still get the alarm. My understanding is the oil pressure/level, hi temperature and low gear lube provide a solid warning, not intermittent.
Had this alarm last year when the old outdrive was still on the boat.
Any ideas please?
Return to FISHING and BOATS FORUM
by ken swanson
(marysville, was)
1994 johnson 88 spl, started it yesterday no problem, disconnected gas line and ran gas out of motor but forgot to turn key off. 12 hours later awakened to alarm going off (steady alarm like overheating) disconnected battery, restarted it ran it for awhile but the alarm keeps sounding off. what gives??? ken
Return to FISHING and BOATS FORUM
by Brn
(Hanford, Ca)
2010 Bayliner 3.0 eng 1A331339. At start up get 5 sec beep (Normal) then 1 beep every minute. Tech says fault code 396. Found part of wiring harness being smashed. Complete wiring harness replaced. Same fault. Eng runs fine good power.
Return to FISHING and BOATS FORUM
by Mike
(Indiana)
Why does my engine start to beep (115hp Mercury IO) when I get up to 3000rpm or when I tilt the engine down?
Return to FISHING and BOATS FORUM
by Dave Carlson
(Dayton,mn.)
2008 z 20 ranger,no power to front panel.checked wiring and connections up front,all look good.Crawled under steering counsel and see flashing red light on distribution box,not sure if that is normal.
Return to FISHING and BOATS FORUM
My name is Nick and I own a 2002 Hurricane deck boat. Recently, I have heard a beeping noise emitting from the control panel every 3 minutes or so and can't figure out why. Fluids are fine. Any thoughts? Can it be a problem with the depth finder.
Return to FISHING and BOATS FORUM
by Roger
(Kenbridge, Va)
My 16' Sylvan with a 40hp Mercury outboard has set up for a while. I just replaced the water pump.
It has a beeping alarm that stays on even though there is a good stream of water coming out through the center of the prop.
Any ideas as to what the problem is? It did not do that the last time I used it. The oil tank is about half full.
Return to FISHING and BOATS FORUM
by George
1993 see swirl you have plenty of oil and oil and gas mixture and after a few minutes I cannot get the boat to stop
Return to FISHING and BOATS FORUM
by Donnie
(Troy, mo)
I have an 01 rinker 212 with a 305/5.0. All day no problem. I went to slow down from about 20-25 to idle and i got a long beep noise.. turned off, start back up. No other problem. Why the long beep?.
Return to FISHING and BOATS FORUM
by Rob
(Tennessee)
I have a 2015 mercury four stoke 60/40 jet. I had the engine alarm go off and when I pulled the motor cover and looked things over I noticed I was low on oil. I refilled the oil back to normal operating level and probably had it out 6 or 7 trips with no issues. I took it the other day and the alarm went back off and I pulled it on the bank to check the oil again and it was full. Any suggestions on what it could be??
Return to FISHING and BOATS FORUM
by Shaz Ahmad
(lagoon city. canada)
I have a 2013 Larson lsr 2300. When I start the boat it beeps once (which is normal). Theb after I start the engine another beep sounds and it beeps constant for about 2 min or so. I called the dealer and he said to check all my fluid levels (which I did) and it still beeps.
Once I throttle down it stops beeping.
Return to FISHING and BOATS FORUM
When we turn on our Kayot the noise it makes when you turn the key will not shut off as it normally does.